RDF System Management Manual for J-series and H-series RVUs (RDF Update 13)

STOP UPDATE
The STOP UPDATE command suspends updating of the backup database and stops all updater
processes.
Where Issued: Primary system only.
Security: Super-user group member with remote password from the primary system to the backup.
STOP UPDATE [, TIMESTAMP timestamp ]
TAKEOVER
The TAKEOVER command causes the backup database to become the database of record.
Where Issued: Backup system only.
Security: Super-user group member.
TAKEOVER [!]
UNPINAUDIT
The UNPINAUDIT command unpins TMF audit trail files on the primary system.
Where Issued: Primary system only.
Security: Super-user group member.
UNPINAUDIT
VALIDATE CONFIGURATION
The VALIDATE CONFIGURATION command validates the parameters in the RDF configuration
file.
Where Issued: Primary system only.
Security: Super-user group member.
VALIDATE CONFIGURATION [, REPORT [filename]]
RDFSCAN Commands Quick Reference
RDFSCAN runs under the Guardian user interface (normally the TACL command interpreter) to the
NonStop operating system. The RDFSCAN command starts an RDFSCAN session that lets you
enter RDFSCAN commands interactively, noninteractively, or through a command file.
Where issued: primary or backup system.
Security: Any user.
RDFSCAN [ file ]
AT
The AT command specifies the record in the RDF log file at which RDFSCAN begins the next
operation.
AT [record-number]
DISPLAY
The DISPLAY command enables or disables the display of line (record) numbers in subsequent
RDFSCAN output.
DISPLAY {ON | OFF}
EXIT
The EXIT command ends your current RDFSCAN session.
EXIT
RDFSCAN Commands Quick Reference 347