RDF System Management Manual for J-series and H-series RVUs (RDF Update 13)

935
The number of image trail files <count> on image trail <volumename> is
greater than the threshold value of 25.
<count>
is the number of image trail files.
<volumename>
is the respective image trail volume.
Cause
After completing a purge pass for the specified image trail volume, the purger found that the
specified number of image trail files still remained in the image trail volume.
Effect
Purger continues normal execution and the purge pass terminates as expected.
Recovery
This is an informational message. No action is needed.
RDFCOM Messages
The following pages list all messages generated by RDFCOM. These messages appear on your
terminal screen during an RDFCOM session. Alternatively, they can be directed to another output
device or file through the OUT command, issued during an RDFCOM session or the OUT parameter
entered in the RDFCOM command that begins the session. The messages appear in alphabetic
order by message text.
$ character detected in the mapping string mapping-string in the MAPFILE
filename
mapping-string
is the erroneous mapping string specified in the mapfile.
filename
is the name of the updater mapfile specified in the updater configuration.
Cause
RDFCOM detected a $ character in the mapping string specified in the updater mapfile when
an ADD VOLUME, ALTER VOLUME, START RDF, START UPDATE, or VALIDATE CONFIGURATION
command was being executed.
Effect
The command fails.
Recovery
Correct the mapping string by removing the $ character, then reenter the command.
Allocation error error# on IMAGETRAIL volume-name
error#
is the file-system error number that identifies the specific error.
volume-name
is the image trail volume on which insufficient storage exists.
Cause
During execution of a START RDF command or a VALIDATE CONFIGURATION command,
RDFCOM determined that sufficient disk storage for image files did not exist in each secondary
image trail for at least one additional image file. As one of its validation checks during processing
of these commands, RDFCOM tries to create a temporary image file on the IMAGETRAIL volume
and then attempts to allocate all extents for it. This allocation failed for the reason indicated by
the file-system number error#.
RDFCOM Messages 419