RDF System Management Manual for J-series and H-series RVUs (RDF Update 13)

Effect
The command fails.
Recovery
See the Guardian Procedure Errors and Messages Manual for a description of and recovery
actions for the file-system error. Correct the error indicated by error#. This might necessitate
altering the IMAGETRAIL configuration parameter to specify a new volume for the secondary
image trail. Then, reenter the START RDF or VALIDATE command.
ALTER Failed: error#
error#
is the file-system error number that identifies the specific error.
Cause
An ALTER command failed.
Effect
The ALTER operation was not completed.
Recovery
See the Operator Messages Manual for a description of the error code. For additional details
about understanding and correcting file-system errors, see the Guardian Procedure Errors and
Messages Manual. If possible, correct the error and reenter the command that encountered the
error. Otherwise, see your system manager.
ALTER of this element cannot be performed with RDF up
Cause
An ALTER command was issued for a non-runtime ALTER option.
Effect
The command fails.
Recovery
Either shut down RDF and reenter the ALTER command, or select another command to enter.
ALTER of this element cannot be performed with updaters running
Cause
An ALTER command was issued for a non-runtime ALTER option.
Effect
The command fails.
Recovery
Stop updating by entering the STOP UPDATE command through RDFCOM, and then reenter the
ALTER command.
ALTER RECEIVER RDFVOLUME is no longer supported
Cause
RDFCOM no longer supports this command.
Effect
The command fails.
Recovery
Select another command.
Ambiguous timestamp for operation
420 Messages