RDF System Management Manual for J-series and H-series RVUs (RDF Update 13)

Cause
You tried to add an updater with the specified ATINDEX, but there is no receiver with that value.
Effect
The ADD command fails.
Recovery
Reenter the ADD command specifying a correct ATINDEX.
Backup node in network master record is incorrect primary system
Cause
The network master network record does not have the have the specified backup system name
for the local RDF subsystem.
Effect
Validation fails.
Recovery
You must reconfigure your network master.
BACKUPSYSTEM is Not Defined
Cause
The RDF configuration file is invalid.
Effect
The RDF configuration record was not added.
Recovery
Enter a SET RDF command, using the BACKUPSYSTEM parameter to identify the backup system.
Then, enter an ADD RDF command to add this system to the configuration.
BACKUPSYSTEM \node is Unavailable
node
is the name of the backup node that was unavailable.
Cause
Either the START RDF command failed because the backup node was unavailable, or the RDF
configuration file is invalid.
Effect
The command or requested operation fails.
Recovery
Examine the RDF configuration file, and correct it if necessary. Otherwise, reenter the START
RDF command when the backup node becomes available.
Broadcast ALTER Failed: error# on component
error#
is the file-system error number that identifies the specific error.
component
is the name of the RDF component for which the ALTER command failed.
Cause
An ALTER command failed for the specified components.
Effect
The command fails.
Recovery
See the Operator Messages Manual for a description of the error code. For additional details
about understanding and correcting file-system errors, see the Guardian Procedure Errors and
RDFCOM Messages 423