RDF System Management Manual for J-series and H-series RVUs (RDF Update 13)

error#
is the file-system error number that identifies the specific error.
filename
is the name of an RDF configuration file on the control subvolume.
Cause
While RDF was attempting to check if an RDF control file existed in
$SYSTEM.control-subvolume on the backup system, file-system error error# was returned.
Effect
The INITIALIZE RDF command aborts.
Recovery
See the Operator Messages Manual for a description of the error code. For additional details
about understanding and correcting file-system errors, see the Guardian Procedure Errors and
Messages Manual. Analyze and correct the problem, and then retry the INITIALIZE RDF command.
Error error# encountered reading config file.
error#
is the file-system error number that identifies the specific error.
Cause
During execution of a LIST UPDATERFILEOPENS command, RDFCOM encountered an error while
reading the RDF CONFIG file during validation of the Updater process names specified by the
user.
Effect
LIST UPDATERFILEOPENS command fails
Recovery
See the Guardian Procedure Errors and Messages Manual for a description of the recovery
actions for the file-system error. Correct the error indicated by error#, then reissue the command.
Error error# obtained in attempting to unpin audit
error#
is the file-system error number that identifies the specific error.
Cause
The TMP returned the specified file-system error number when attempting to unpin a TMF audit
trail file.
Effect
The UNPINAUDIT command is ignored.
Recovery
See the Operator Messages Manual for a description of the error code. For additional details
about understanding and correcting file-system errors, see the Guardian Procedure Errors and
Messages Manual. Take appropriate corrective action, and then reissue the UNPINAUDIT
command.
Error error# obtaining FILECODE and CRVSN of the MAPFILE filename
error#
is the file-system error number that identifies the specific error.
filename
is the name of the updater mapfile specified in the updater configuration.
Cause
RDFCOM could not obtain the file code and CRVSN of the updater mapfile when an ADD
VOLUME, START RDF, START UPDATE, or VALIDATE CONFIGURATION command was being
executed.
428 Messages