RDF System Management Manual for J-series and H-series RVUs (RDF Update 13)

Cause
An ADD EXTRACTOR command was issued when the configuration file already contained an
extractor record.
Effect
The command fails.
Recovery
No recovery is required if you want to use the existing extractor process as configured. If you
want to change any of the extractor’s configuration options, however, enter an ALTER EXTRACTOR
command that specifies those changes.
EXTRACTOR record NOT found
Cause
The INFO command could not find an extractor record in the configuration file.
Effect
The command fails.
Recovery
Alter the configuration to include an extractor process.
FASTUPDATEMODE is not turned ON for Master Receiver.
Cause
You have turned FASTUPDATEMODE ON for an Auxillary Receiver when the FASTUPDATEMODE
is OFF for the Master Receiver.
Effect
The command fails.
Recovery
Set FASTUPDATEMODE ON for the Master Receiver before setting FASTUPDATEMODE ON for
any Auxiliary Receiver.
FASTUPDATEMODE should be turned OFF for all the Auxilliary Receivers
before it is turned OFF for the Master Receiver.
Cause
You have tried to turn FASTUPDATEMODE OFF for the Master Receiver when FASTUPDATEMODE
is ON for one or more Auxilliary Receivers.
Effect
FASTUPDATEMODE will not be turned OFF for the Master Receiver.
Recovery
Check the FASTUPDATEMODE of all the auxilliary receivers and set it to OFF for all those which
have FASTUPDATEMODE ON before reissuing the command.
Filename is not licensed.
Filename
is the name of an RDF program file that is used to create an RDF subsystem process.
Cause
When a START RDF command or a VALIDATE CONFIGURATION command is executed,
RDFCOM determined that the program file used for creating a RDF subsystem process is not
licensed.
Effect
The command fails.
Recovery
License the program file. Then, reenter the START RDF or VALIDATE command.
RDFCOM Messages 435