RDF System Management Manual for J-series and H-series RVUs (RDF Update 13)

mapping-string
is the erroneous mapping string specified in the MAPFILE.
index
is the erroneous position in the mapping string.
filename
is the name of the updater MAPFILE specified in the updater configuration.
Cause
RDFCOM detected that the mapping string is invalid at the position indicated by index when
an ADD VOLUME, ALTER VOLUME, START RDF, START UPDATE, or VALIDATE CONFIGURATION
command was being executed.
Effect
The command fails.
Recovery
Correct the mapping string, then reenter the command.
Master EXTRACTOR Record already exists
Cause
You have already added an extractor with an ATINDEX value of 0.
Effect
The ADD EXTRACTOR command fails.
Recovery
Review and revise your RDF configuration.
Master RECEIVER Record already exists
Cause
You have already added a receiver with an ATINDEX value of 0.
Effect
The ADD EXTRACTOR command fails.
Recovery
Review and revise your RDF configuration.
Maximum number of image trails already added
Cause
You have already added the maximum number of secondary image trails (255), and cannot
add more.
Effect
The command fails.
Recovery
No recovery action is possible; your RDF subsystem can only support 256 secondary image
trails.
Missing network master NETWORK record
Cause
No network record exists that corresponds to the network master subsystem.
Effect
RDF does not start.
Recovery
Add a network record to describe the network master subsystem.
RDFCOM Messages 445