RDF System Management Manual for J-series and H-series RVUs (RDF Update 13)

MONITOR Record exists, use ALTER MONITOR
Cause
An ADD MONITOR command was issued when the configuration file already contained a
monitor record.
Effect
The command fails.
Recovery
No recovery is required if you want to use the existing monitor process as configured. If you
want to change any of the monitor’s configuration options, however, enter an ALTER MONITOR
command that specifies those changes.
MONITOR record NOT found
Cause
The INFO command could not find a monitor record in the configuration file.
Effect
The command fails.
Recovery
Alter the configuration to include the monitor process.
Network options are only available with the RDF/IMPX product
Cause
You have attempted to specify configuration information for an RDF network, but you do not
have an RDF/IMPX license.
Effect
The configuration command fails.
Recovery
If you need to run in an RDF network, you need to obtain the RDF/IMPX license and product.
NETWORK record can only be added into a networked subsystem
Cause
An ADD NETWORK command was entered but the RDF NETWORK parameter is set OFF.
Effect
The ADD NETWORK command is rejected.
Recovery
Reconfigure RDF to have the RDF NETWORK parameter set ON.
Network record not found
Cause
The current RDF subsystem is configured in an RDF network, but a network record has not been
added.
Effect
Validation fails.
Recovery
You must add the appropriate NETWORK configuration record.
Network synch file ZRDFNETX file must be INCLUDED
Cause
An INCLUDE pattern has been specified that will cause audit records associated with the NetSynch
data file to be filtered out.
446 Messages