RDF System Management Manual for J-series and H-series RVUs (RDF Update 13)

Cause
The RDF configuration file is invalid.
Effect
The configuration validation fails.
Recovery
Check the updater process parameters in the configuration file for invalid values and correct
any errors found.
No VOLUMES are configured for ATINDEX atindex
Cause
You added an extractor and receiver with the specified ATINDEX, but there are no updaters
with that value.
Effect
The validation fails.
Recovery
Add at least one updater with the same ATINDEX value or delete the particular extractor-receiver
pair.
Obtained error error# in attempting to examine remote imagetrail files
error#
is the file-system error number that identifies the specific error.
Cause
The COPYAUDIT command encountered the specified error in attempting to read the remote
image trail files.
Effect
The command fails.
Recovery
See the Operator Messages Manual for a description of the error code. For additional details
about understanding and correcting file-system errors, see the Guardian Procedure Errors and
Messages Manual. If possible, correct the error and reenter the COPYAUDIT command.
Otherwise, see your system manager.
Only one Network record is allowed for a non-network master
Cause
Your current RDF configuration does not have the NetworkMaster attribute set and you have
tried to add more than one network record.
Effect
The configuration command fails.
Recovery
If the network record you have previously added pertains to the RDF network master subsystem,
then do not add any further network records. If the network record you have previously added
does not pertains to the RDF network master subsystem, then you need to purge your current
configuration, reinitialize, and reconfigure.
Only the SUPER group can execute this command
Cause
You issued a command restricted to members of the super ID group, but your logon ID does not
indicate that group.
Effect
The command fails.
RDFCOM Messages 449