RDF System Management Manual for J-series and H-series RVUs (RDF Update 13)

Cause
The command can be issued only at the backup system.
Effect
The command fails.
Recovery
Enter another command.
Operation can only be performed on the PRIMARYSYSTEM \primary
primary
is the name of the primary node that can perform the operation.
Cause
The command can be issued only at the primary node.
Effect
The command fails.
Recovery
Enter another command.
Operation is NOT allowed when RDF is running
Cause
The command is not allowed while RDF is running.
Effect
The command fails.
Recovery
Enter another command, or shut down RDF and reenter this command.
Operation must be performed on the PRIMARYSYSTEM \primary or BACKUPSYSTEM
\backup
primary
is the name of the primary node that can perform the operation.
backup
is the name of the backup node that can perform the operation.
Cause
The command was issued at a third system, which is not allowed.
Effect
The command fails.
Recovery
Enter another command, or reenter this command at the specific primary or backup node reflected
by this message.
Please wait while RDF searches for the specified shutdown timestamp
Cause
You entered an INITIALIZE RDF command that attempted to initialize RDF at a specific TMF
shutdown timestamp, and responded YES or Y to the subsequent confirmation prompt, directing
the subsystem to proceed with the initialization.
Effect
RDFCOM reads backward through the MAT in search of a TMF shutdown record with the same
timestamp you specified.
RDFCOM Messages 451