RDF System Management Manual for J-series and H-series RVUs (RDF Update 13)

Recovery
This is an informational message; no recovery is required. You can terminate the operation at
any time by pressing the BREAK (or equivalent) key.
PNETTXVOLUME volume for ctrl-subvol must be protected by a MAT
based-updater
volume
is the name of an RDF data volume.
ctrl-subvol
is the name of an RDF subsystem control subvolume.
Cause
The specified volume for the RDF subsystem with the specified control subvolume is not configured
to the Master Audit Trail (MAT).
Effect
Validation fails.
Recovery
The PNETTXVOLUME must be configured to the Master Audit Trail (MAT). You need to reconfigure
your network master and the subsystem with the specified control subvolume.
PNETTXVOLUME volume is not configured to a MAT based updater
volume
is the name of an RDF data volume.
Cause
The specified PNETTXVOLUME is not configured to a MAT based updater.
Effect
Validation fails.
Recovery
You must reconfigure your network master and possibly your local configuration.
Position error error# on file remote-config-file
error#
is the file-system error number that identifies the specific error.
remote-config-file
is the name of the remote configuration file.
Cause
The COPYAUDIT command encountered the specified error while attempting to position into the
remote configuration file.
Effect
The COPYAUDIT command aborts.
Recovery
See the Operator Messages Manual for a description of the error code. For additional details
about understanding and correcting file-system errors, see the Guardian Procedure Errors and
Messages Manual. If possible, correct the error and reenter the COPYAUDIT command.
Otherwise, contact your service provider.
Position error error# on local image file
error#
is the file-system error number that identifies the specific error.
452 Messages