RDF System Management Manual for J-series and H-series RVUs (RDF Update 13)

Effect
The Report generation fails.
Recovery
See the Guardian Procedure Errors and Messages Manual for a description of the recovery
actions for the file-system error. Correct the error indicated by error#, then reenter the command.
Primary node in network master record is incorrect primary-system
primary-system
is an RDF system name.
Cause
The network master network record does not have the specified primary system name.
Effect
Validation fails.
Recovery
You must reconfigure your network master.
PRIMARYSYSTEM (\node) and BACKUPSYSTEM (\node) are the same
node
is the name assigned to both the primary and backup nodes.
Cause
The RDF configuration file is invalid: both primary and backup node names are identical.
Effect
The validation fails.
Recovery
Alter the RDF configuration to reflect different names for these two nodes.
Process Name Error: error#
error#
is the error number that identifies the specific error.
Cause
A NEWPROCESS error occurred during START RDF or TAKEOVER processing.
Effect
The START RDF or TAKEOVER operation is aborted.
Recovery
See the Operator Messages Manual for a description of the error code. For additional details
about understanding and correcting process errors, see the Guardian Procedure Errors and
Messages Manual. If possible, correct the error and reenter the command that encountered the
error. Otherwise, contact your service provider.
Process procname already used in Control Subvolume Ctrl-subvol.
procname
is the name of the RDF process you specified in the current configuration.
Ctrl-Subvol
is the name of the RDF subsystem control subvolume.
Cause
When a START RDF command or a VALIDATE CONFIGURATION command is executeds,
RDFCOM determined that a user specified process name is already in use in a different RDF
environment.
454 Messages