RDF System Management Manual for J-series and H-series RVUs (RDF Update 13)

RDF already in TAKEOVER processing
Cause
The operator issued a TAKEOVER command at the backup node while RDF was performing a
TAKEOVER operation.
Effect
The last TAKEOVER command is ignored.
Recovery
This is an informational message; no recovery is required.
RDF configuration file is not open, use OPEN command
Cause
The configuration file must be open before any RDFCOM commands other than OPEN or OBEY
can be executed.
Effect
The attempted operation is aborted.
Recovery
Open the configuration file with the OPEN command.
RDF has not been initialized.
Cause
You issued an INITIALIZE RDF command, but entered NO or N in response to the subsequent
confirmation prompt for continuing the initialization process.
Effect
RDF is not initialized.
Recovery
This is an informational message; no recovery is required.
RDF LOGFILE filename NOT a legal filename on system \node
filename
is the name of the nonexistent EMS collector (RDF log file).
node
is the name of the system where the collector name is invalid.
Cause
The RDF configuration file is invalid: a nonexistent EMS collector was specified.
Effect
The ADD RDF command fails.
Recovery
Specify a valid EMS collector name in a SET RDF command, and then reenter the ADD RDF
command.
RDF network subsystem ctrl-subvol has not been validated
ctrl-subvol
is the name of an RDF subsystem control subvolume.
Cause
Your are attempting to validate the network master of your RDF network before you have validated
all non network master subsystems.
Effect
Validation fails.
456 Messages