RDF System Management Manual for J-series and H-series RVUs (RDF Update 13)

Recovery
Validate all your non network master subsystems and then validate your local subsystem.
RDF (\primary -> \backup) is NOT running
Cause
A STATUS RDF or STOP RDF command was issued while RDF was stopped.
Effect
The command fails.
Recovery
Reissue the command after RDF is started.
RDF record exists, use ALTER RDF
Cause
An ADD RDF command was issued when the configuration file already contained an RDF global
record.
Effect
The command fails.
Recovery
No recovery is required if you want to use the subsystem with the existing RDF global parameters
configured. If you want to change any of the global parameters, however, enter an ALTER RDF
command that specifies those changes.
RDF record NOT found
Cause
The INFO command could not find an RDF global record in the configuration file.
Effect
The command fails.
Recovery
Alter the configuration to include all RDF global parameters.
RDF Shutdown in progress, please wait...
Cause
RDF is shutting down.
Effect
The shutdown operation continues.
Recovery
This is an informational message; no recovery is required.
RDF START Failure, Scan LOGFILE for reason
Cause
A START RDF command failed. RDF writes a description of the problem in the LOGFILE.
Effect
The START RDF command fails.
Recovery
Check the EMS event log for the message covering this error. If possible, correct the cause of
the error and reissue the START RDF command. Otherwise, contact your system manager.
RDF subsystem ctrl-subvol is not configured as a Network master
RDFCOM Messages 457