RDF System Management Manual for J-series and H-series RVUs (RDF Update 13)

Effect
The configuration command fails.
Recovery
Do not add this record.
RDFVOLUME in network master record is incorrect rdf-vol.
rdf-vol
is the RDFVOLUME specified in the network record of the network master.
Cause
The RDFVOLUME of the current RDF configuration does not match the value specified in the
network record of the network master.
Effect
Validation fails.
Recovery
You must reconfigure your network master and possibly your local configuration.
RDFVOLUME in network master record is invalid.
Cause
The RDFVOLUME of the current RDF configuration is invalid in the network record of the network
master.
Effect
Validation fails.
Recovery
You must reconfigure your network master and possibly your local configuration.
RDFVOLUME is not allowed for an aux receiver. Auxiliary receivers do
not have an RDFVOLUME.
Cause
You tried to add an auxiliary receiver for which you had specified an RDFVOLUME.
Effect
The ADD command fails.
Recovery
Issue a RESET RECEIVER command, and then reconfigure the particular receiver without specifying
an RDFVOLUME.
Read error error# on file remote-config-file
error#
is the file-system error number that identifies the specific error.
remote-config-file
is the name of the remote configuration file.
Cause
The COPYAUDIT command encountered the specified error while attempting to read the remote
configuration file.
Effect
The COPYAUDIT command aborts.
Recovery
See the Operator Messages Manual for a description of the error code. For additional details
about understanding and correcting file-system errors, see the Guardian Procedure Errors and
RDFCOM Messages 459