RDF System Management Manual for J-series and H-series RVUs (RDF Update 13)

Messages Manual. If possible, correct the underlying error and reenter the COPYAUDIT command.
Otherwise, contact your service provider.
Read error error# on remote image file
error#
is the file-system error number that identifies the specific error.
Cause
The COPYAUDIT command encountered the specified error while attempting to read data from
a remote image file on the remote image trail.
Effect
The COPYAUDIT command aborts.
Recovery
See the Operator Messages Manual for a description of the error code. For additional details
about understanding and correcting file-system errors, see the Guardian Procedure Errors and
Messages Manual. If possible, correct the underlying error and reenter the COPYAUDIT command.
Otherwise, see your service provider.
Read error error# on remote ZFILEINC file
error#
is the file-system error number that identifies the specific error.
Cause
The COPYAUDIT command encountered the specified error while attempting to read data from
the remote ZFILEINC file.
Effect
The COPYAUDIT command aborts.
Recovery
See the Operator Messages Manual for a description of the error code. For additional details
about understanding and correcting file-system errors, see the Guardian Procedure Errors and
Messages Manual. If possible, correct the underlying error and reenter the COPYAUDIT command.
Otherwise, contact your service provider.
RECEIVER RDFVOL error error# on allocation
error#
is a file-system error number that indicates lack of storage space on disk.
Cause
During execution of a START RDF command, RDFCOM determined that sufficient disk storage
for image files did not exist.
As one of its validation checks during START RDF processing, RDFCOM tries to create a temporary
image file on the receiver’s RDFVOLUME and then to allocate all 16 extents. This check, if
successful, verifies that:
• If RDF is starting for the first time, there is enough storage for at least one image file
• If RDF has been started previously, there is enough storage for one image file when the next
image-file rollover occurs
If the check fails because there is insufficient storage, this message appears.
Effect
The START RDF command is aborted.
Recovery
See the Operator Messages Manual for a description of the error code. For additional details
about understanding and correcting file-system errors, see the Guardian Procedure Errors and
460 Messages