RDF System Management Manual for J-series and H-series RVUs (RDF Update 13)

Recovery
Add the receiver’s record. Then, add the secondary image trail.
RECEIVER record exists, use ALTER RECEIVER
Cause
An ADD RECEIVER command was issued when the configuration file already contained a receiver
record.
Effect
The command fails.
Recovery
No recovery is required if you want to use the existing receiver process as it is configured. If
you want to change any of the receiver’s configuration options, however, enter an ALTER
RECEIVER command that specifies those changes.
RECEIVER record NOT found.
Cause
The INFO command could not find a receiver record in the configuration file.
Effect
The command fails.
Recovery
Alter the configuration to include a receiver process.
Receiver record not found for subsystem ctrl-subvol.
ctrl-subvol
is the name of an RDF subsystem control subvolume.
Cause
RDFCOM was unable to read the receiver record for the RDF subsystem with the specified control
subvolume.
Effect
Validation fails.
Recovery
Determine why the receiver record for the subsystem cannot be obtained.
RECEIVER Record with ATINDEX atindex does not exist.
Cause
You tried to add an imagetrail with the specified ATINDEX, but there is no receiver with that
value.
Effect
The ADD command fails.
Recovery
You must add the corresponding receiver process before adding an imagetrail with the same
ATINDEX value.
Remote system for Triple Contingency CopyAudit command is unavailable:
remote-system
remote-system
is the name of the RDF backup system that received the most audit.
Cause
You entered a COPYAUDIT command, but remote-system cannot be reached because of a
network problem.
462 Messages