RDF System Management Manual for J-series and H-series RVUs (RDF Update 13)

SUFFIX must be a single alphanumeric character
Cause
You specified an incorrect value for the SUFFIX option of the INITIALIZE RDF command.
Effect
The INITIALIZE RDF command is aborted.
Recovery
Reenter the command, specifying a single alphanumeric character for the suffix character.
Swap File Error: error#
error#
is the file-system error number that identifies the specific error.
Cause
A NEWPROCESS error occurred during START RDF or TAKEOVER processing.
Effect
The command fails.
Recovery
See the Operator Messages Manual for a description of the error code. For additional details
about understanding and correcting process errors, see the Guardian Procedure Errors and
Messages Manual. If possible, correct the error and reenter the command that encountered the
error. Otherwise, see your system manager.
Synch point for synchdbtime has been found
synchdbtime
is a SYNCHDBTIME timestamp specified previously by an operator in an RDFCOM INITIALIZE
RDF command.
Cause
In conjunction with a complete database synchronization, a record whose timestamp is less than
synchdbtime has been located successfully.
Effect
The RDFCOM INITIALIZE RDF command continues.
Recovery
This is an informational message; no recovery is required.
Synch timestamp is synchdbtime
synchdbtime
is a SYNCHDBTIME timestamp specified previously by an operator in an RDFCOM INITIALIZE
RDF command.
Cause
In conjunction with a complete database synchronization, you are attempting to initialize RDF
to a timestamp that is earlier than the current time. A record whose timestamp is less than
synchdbtime has been found, and synchdbtime has been stored in the RDF configuration
record.
Effect
The RDFCOM INITIALIZE RDF command continues.
Recovery
This is an informational message; no recovery is required.
TAKEOVER in progress
468 Messages