RDF System Management Manual for J-series and H-series RVUs (RDF Update 13)

Cause
You must specify a process name for the extractor process before issuing an ADD command.
Effect
The start command fails.
Recovery
You must reconfigure RDF with a named extractor process.
The last record in the local imagetrail on volume-name.subvolume-name
could not be found in the remote trail
volume-name
is the name of the image trail’s volume
subvolume-name
is the name of the image trail’s subvolume.
Cause
The COPYAUDIT command could not find the last record in the local image trail on the remote
image trail. This problem indicates that the receiver’s RETAINCOUNT value was probably not
set high enough and that, as a result, some image files on the remote system were purged.
Effect
The COPYAUDIT command aborts.
Recovery
There is no recovery action. The COPYAUDIT command cannot be executed because image
files needed for this command were already purged from the remote system.
The MAPFILE filename is not found
filename
is the name of the updater mapfile specified in the updater configuration.
Cause
RDFCOM could not find the updater mapfile when an ADD VOLUME, ALTER VOLUME, START
RDF, START UPDATE, or VALIDATE CONFIGURATION command was being executed.
Effect
The command fails.
Recovery
Provide an existing mapfile and reenter the command.
The MAPFILE filename should be an edit file
filename
is the name of the updater mapfile specified in the updater configuration.
Cause
RDFCOM found that the updater mapfile is not an EDIT format file when an ADD VOLUME,
ALTER VOLUME, START RDF, START UPDATE, or VALIDATE CONFIGURATION command was
being executed.
Effect
The command fails.
Recovery
Provide an edit file and reenter the command.
The MAPLOG file filename could not be created: error error#
filename
is the name of the updater maplog specified in the updater configuration.
470 Messages