RDF System Management Manual for J-series and H-series RVUs (RDF Update 13)

The number of physical UPDATEVOLUMES exceeds 255. RDF/IMPX is required
for this many volumes.
Cause
RDF has detected that the user is running RDF/IMP and the total number of physical volumes for
all UPDATEVOLUMEs exceeds 255. This can happen where some, or all, of the UPDATEVOLUMEs
are SMF virtual disks.
Effect
RDF will not start.
Recovery
Upgrade the RDF software to RDF/IMPX or reconfigure your disks on the RDF backup node so
that the total number of physical disks for all the UPDATEVOLUMEs is less than 255.
The PURGER must be a named process
Cause
You must specify a process name for the purger process before issuing an ADD command.
Effect
The start command fails.
Recovery
You must reconfigure RDF with a named purger process.
The RDF primary system in the environment you are attempting to copy
audit from does not match the primary system in this environment.
Cause
The COPYAUDIT command detected that the RDF primary system in the RDF environment you
are attempting to copy audit from is not the same as the RDF primary system in the local
environment.
Effect
The COPYAUDITcommand aborts.
Recovery
Correct the REMOTESYS remote-sys and REMOTECONTROLSUBVOL rcvs parameters and
reissue the COPYAUDIT command.
RDFNET must be a named process
Cause
You must specify a process name for the RDFNET process before issuing an ADD command.
Effect
The start command fails.
Recovery
You must reconfigure RDF with a named RDFNET process.
"The remote control subvolume\bksys.$SYSTEM.subvol is not empty. The
files on the remote control subvolume must be purged. Please note, these
files might belong to another RDF configuration.
\bksys
is the name of the RDF backup system.
subvol
is the name of the remote control subvolume.
472 Messages