RDF System Management Manual for J-series and H-series RVUs (RDF Update 13)

max
is 64 for RDF, and 255 for the RDF/MP, MPX, IMP, or IMPX
Cause
The maximum number of volumes that can be protected on a node (64 for RDF, 255 for RDF/MP,
MPX, IMP, or IMPX) has been exceeded.
Effect
The configuration validation fails.
Recovery
Delete some of the volumes.
Too many volumes are specified in this ALTER command
Cause
You specified too many volumes in the command parameter list of an ALTER command.
Effect
The ALTER command aborts.
Recovery
Eliminate some of the volumes from the command parameter list.
Triple Contingency CopyAudit command aborted.
Cause
The COPYAUDIT command has aborted because of a problem reported in the previous RDFCOM
message.
Effect
The COPYAUDIT command aborts.
Recovery
Correct the problem reported in the previous error message and reissue the COPYAUDIT
command.
Unable to allocate Map
Cause
A NEWPROCESS error occurred during START RDF or TAKEOVER processing.
Effect
The NEWPROCESS procedure fails.
Recovery
Make sufficient space available on the swap volume for the requested operation.
Unable to communicate with CPU cpu
cpu
is the CPU that is not responding.
Cause
A NEWPROCESS error occurred during START RDF or TAKEOVER processing.
Effect
The NEWPROCESS procedure fails.
Recovery
Check the status of the CPU, or enter SET and ALTER commands to direct the process to run on
a different CPU.
Unable to get MAT filename with sequence number seq-num from the TMP;
search stopped.
RDFCOM Messages 477