RDF System Management Manual for J-series and H-series RVUs (RDF Update 13)

seq-num
is the sequence number of the MAT file.
Cause
RDFCOM could not obtain the fully qualified name of the audit trail file with the specified
sequence number from the TMP.
Effect
RDFCOM terminates the search for a TMF shutdown timestamp and then its attempt to initialize
RDF.
Recovery
Check to see if TMF is started:
• If it is not, start TMF before you again attempt to initialize RDF.
• If it is running and this error occurs, this is an internal error. Contact the Global Mission
Critical Solution Center (GMCSC) or your service provider.
Unable to obtain the process access id of RDFCOM
Cause
RDFCOM could not obtain the process access id of the user who started the RDFCOM session.
Effect
The ADD command fails.
Recovery
Exit RDFCOM and then try again. If the problem persists, contact the Global Mission Critical
Solution Center (GMCSC) or your service provider.
Unable to purge old image file due to error error# DELETE ABORTED
error#
is the file-system error number that identifies the specific error.
Cause
A START RDF command failed because the reported error prevented RDFCOM from purging the
old image file.
Effect
The command fails.
Recovery
See the Operator Messages Manual for a description of the error code. For additional details
about understanding and correcting file-system errors, see the Guardian Procedure Errors and
Messages Manual. Manually purge any files on the image file subvolume, and then reissue the
START RDF command.
Unable to purge remaining image files; error error#
error#
is the file-system error number that identifies the specific error.
Cause
A DELETE IMAGETRAIL command tried to delete an image trail, but RDFCOM could not purge
all image files in the trail because of the error denoted by file-system file-error.
Effect
The command fails.
Recovery
See the Operator Messages Manual for a description of the error code. For additional details
about understanding and correcting file-system errors, see the Guardian Procedure Errors and
Messages Manual. Correct the error and reenter the command.
478 Messages