RDF System Management Manual for J-series and H-series RVUs (RDF Update 13)

Cause
You are attempting to initialize RDF in conjunction with a complete database synchronization.
Effect
If an audit record can be found whose timestamp is less than the specified timestamp, RDF is
initialized to that record.
Recovery
This is an informational message; no recovery is required.
* * * WARNING * * * RDF will start at the first record in the TMF master
audit trail whose timestamp is less than the specified timestamp. The
timestamp you specified must follow the documented guidelines. Please
note that RDFCOM will subtract an additional three minutes from the
specified timestamp to ensure a safe restart position.
Cause
You are attempting to initialize RDF to a timestamp that is earlier than the current time, and
database synchronization is not involved.
Effect
If an audit record can be found whose timestamp is less than the specified timestamp, RDF is
initialized to that record. If you were running RDF prior to this initialization command, you should
take into consideration the highest updater RTD. In addition, RDFCOM subtracts another three
minutes from the specified timestamp to ensure that the starting position in the audit trail is a
safe one.
Recovery
This is an informational message; no recovery is required.
*** WARNING *** REPLICATEPURGE is not turned ON.
Cause
REPLICATEPURGE is turned OFF but INCLUDEPURGE or EXCLUDEPURGE lists have been added
for a volume.
Effect
The INCLUDEPURGE or EXCLUDEPURGE lists will be ignored for the volume.
Recovery
SET RDF REPLICATEPURGE to ON before starting RDF.
*** Warning *** Updater Open Mode has been specified the same value as
it was before using the ALTER RDF UPDATEROPEN command.
Cause
The ALTER RDF UPDATEROPEN command has been specified with the same mode which was
present prior to issuing the command.
Effect
The command fails.
Recovery
This is an informational message. No action needed.
Wildcard not supported for include/exclude.
Cause
Wildcard characters were supplied with file names with the ALTER VOLUME command when
including or excluding files while RDF is online.
Effect
The ALTER command fails. The specified file is not included or excluded.
484 Messages