Safeguard Reference Manual (G06.24+, H06.03+ )

Disk Volume and Subvolume Security Commands
Safeguard Reference Manual—520618-013
9-20
INFO VOLUME and SUBVOLUME Commands
For listfile, specify any file name. SAFECOM opens listfile and appends
the INFO report to the file. If listfile does not exist, SAFECOM creates an
EDIT file and writes the INFO report to that file.
volume-list
specifies one or more disk volumes for which INFO reports are to be produced.
volume-list can be either:
$volume
( $volume [ , $volume ] ... )
$volume
can be any volume name. The name can contain wild-card characters.
subvol-list
specifies one or more subvolumes for which INFO reports are to be produced.
subvol-list can be either:
subvol-name
( subvol-name [ , subvol-name ... ] )
subvol-name
can be any subvolume name. The name can contain wild-card characters.
DETAIL
adds the current audit-specs for the volumes or subvolumes being reported. For
a full description of the four audit-specs, see the SET VOLUME and
SUBVOLUME Commands on page 9-26.
INFO VOLUME and SUBVOLUME Brief Report
The brief INFO VOLUME or INFO SUBVOLUME report gives you information about
the volumes or subvolumes you specify. Figure 9-1 illustrates the format of the brief
INFO report for both volumes and subvolumes.
Figure 9-1. INFO VOLUME and SUBVOLUME Brief Report Format
LAST-MODIFIED OWNER STATUS WARNING-MODE
$volume[.subvol]
date, time owner-id status {ON|OFF}
user-spec [DENY] authority
user-spec [DENY] authority
.
.
.
[ NO ACCESS CONTROL LIST DEFINED! ]