Safeguard Reference Manual (G06.24+, H06.03+ )

Device and Subdevice Security Commands
Safeguard Reference Manual—520618-013
10-30
SET DEVICE and SUBDEVICE Commands
NONE
No successful management attempts are audited.
Omitting audit-spec specifies NONE.
AUDIT-MANAGE-FAIL [audit-spec]
establishes an audit-spec for unsuccessful attempts to manage an
authorization record. This audit-spec specifies the conditions under which
an audit record is written to the audit file when an attempt to manage an
authorization record fails.
The form of audit-spec is:
{ ALL | LOCAL | REMOTE | NONE }
ALL
All unsuccessful management attempts are audited.
LOCAL
Only unsuccessful management attempts by local users are audited.
REMOTE
Only unsuccessful management attempts by remote users are audited.
NONE
No unsuccessful management attempts are audited.
Omitting audit-spec specifies NONE.
WARNING-MODE { ON | OFF }
defines whether warning mode is enabled for the specified device or
subdevice. The value is required. For more information on warning mode, see
the Safeguard Administrator's Manual.
ON enables warning mode for the specified device or subdevice. The initial
value is OFF, which disables warning mode for the specified device or
subdevice.
Example
These commands define default values for a new printer:
=ASSUME DEVICE
=SET OWNER prs.manager
=SET AUDIT-ACCESS-PASS all , AUDIT-MANAGE-PASS local
=SET ACCESS 33,* (r,w) ; 86,* *; prs.harry DENY *; 255,* *
These default device attribute values are defined here: