Safeguard Reference Manual (G06.24+, H06.03+ )

Safeguard Subsystem Commands
Safeguard Reference Manual—520618-013
16-19
ALTER SAFEGUARD Command
ALLOW-NODE-ID-ACL { ON | OFF }
defines whether ACL entries containing explicit node identifiers for subjects are
consulted to determine remote access. The initial value is OFF, ignoring ACL
entries containing explicit node identifiers.
CHECK-DISKFILE-PATTERN { OFF | ONLY | FIRST | LAST }
defines diskfile-patterns operations.
OFF
specifies that no pattern searches will occur.
FIRST
specifies that pattern searching will occur first, and if and only if the result
is NORECORD then the normal search for a protection record will occur.
LAST
specifies that pattern searching will occur after the normal search if and
only if the normal search result is NORECORD.
ONLY
specifies that only pattern searching will occur. That is, normal non-pattern
searching will not be performed even if the pattern search returns
NORECORD.
AUDIT-CLIENT-OSS { ON | OFF }
specifies whether the OSS-related audits are written to the Safeguard audit
trial. It allows the auditing of OSS-related operations to be configured
independently of the existing AUDIT-CLIENT-GUARDIAN attribute, and all
other subsystem client auditing. The initial value is ON.
PASSWORD-ALGORITHM { DES | HMAC256 }
indicates the algorithm to encrypt passwords when they are changed. The
initial value is DES.
DES
indicates to use the DES algorithm to encrypt passwords. This is the initial
vaule. Encrypted passwords are stored in the L/USERID and L/USERAX
files.
Note. The AUDIT-CLIENT-OSS attribute is supported only on systems running G06.29
and later G-series RVUs and H06.08 and later H-series RVUs.
Note. The PASSWORD-ALGORITHM attribute is supported only on systems running
G06.29 and later G-series RVUs and H06.06 and later H-series RVUs.