Safeguard Reference Manual (G06.24+, H06.03+ )

SAFECOM Error and Warning Messages
Safeguard Reference Manual—520618-013
A-9
Recovery. Report the problem to your system manager. Your system manager should
ensure that the Safeguard software has been installed properly. If your system
manager cannot solve the problem, report the error to your HP representative. (The
System Messages Manual describes file-system errors.)
Cause. The command failed because you lack the authority required to perform the
command.
Effect. The command is not executed.
Recovery. Ask someone with the required authority to execute the command.
Cause. The SMP encountered an internal error while attempting to execute the STOP
command.
Effect. The command is not executed.
Recovery. Write down the SMP error number and contact your HP representative.
(Your HP representative will need the SMP error number to correct the problem.)
Cause. You attempted an operation on a disk file that resides on a subvolume
reserved for OSS.
Effect. The command is not executed.
Recovery. Specify a disk file on another subvolume and retry the command.
Cause. No disk file names were found to match the criteria specified in a WHERE
clause.
Effect. The command is not executed.
Recovery. Specify another name pattern or another WHERE criterion and then retry
the command.
Cause. One of the attributes in the event-exit process configuration record is invalid.
The value n,nn indicates a file-system or PROCESS_CREATE_ error.
* ERROR * COMMAND FAILED : SECURITY VIOLATION
* ERROR * COMMAND FAILED : SMP ERROR = ####
* ERROR * DISKFILE filename : SUBVOLUME RESERVED FOR OSS
* ERROR * DISKFILE filename : WHERE NOT MATCHED
* ERROR * Failure starting process; error (n,nn) from PROCESS_CREATE_