Safeguard Reference Manual (G06.24+, H06.03+ )

SAFECOM Error and Warning Messages
Safeguard Reference Manual—520618-013
A-10
Effect. The process cannot be started when ENABLED is set to ON.
Recovery. Correct the invalid attribute and then retry the command.
Cause. An attempt to execute an audit service command was rejected because the
specified file’s disk volume is down.
Effect. The command is rejected.
Recovery. Bring up the disk volume and retry the command.
Cause. An attempt to was made to add another event-exit process when one already
exists.
Effect. The command is rejected.
Recovery. Delete the existing event-exit process configuration record and then retry
the command.
Cause. An attempt was made to add another terminal definition with the ADD
TERMINAL command, but the maximum number of terminals has already been
defined. The current maximum is about 420 terminals.
Effect. The command is rejected.
Recovery. None.
Cause. An ADD USER command specified a user name that matches an existing user
alias. (In this check, the user alias is treated as case insensitive.)
Effect. The command is not executed.
Recovery. Reenter the command with a different user name or delete the conflicting
alias name and retry the command.
Cause. You attempted to add a user alias that already exists as a user name.
Effect. The command is not executed.
* ERROR * File system error num from procedure name, file audit-file
* ERROR * Max process entries 1 exceeded.
* ERROR * Maximum number of Terminals (LUs) defined
* ERROR * Name conflicts with existing alias name.
* ERROR * Name conflicts with existing user name.