Safeguard Reference Manual (G06.24+, H06.03+ )

SAFECOM Error and Warning Messages
Safeguard Reference Manual—520618-013
A-31
Effect. The command indicated by the circumflex characters (^^^) is not executed.
Any commands following the indicated command are not executed.
Recovery. Enter the sequence of commands on two or more command lines.
Cause. Too many groups were specified in a command.
Effect. The command is rejected.
Recovery. Reduce the number of groups in the command to 32 or fewer and then
retry the command.
Cause. More than 32 members are being added to a group, or more than 32 members
are being removed from a group.
Effect. The command is rejected.
Recovery. Specify 32 or fewer members in the offending MEMBER clause, and retry
the command.
Cause. Insufficient memory is available in the CPU in which SAFECOM is running.
Effect. The SAFECOM session does not run properly.
Recovery. Try again later or try running SAFECOM in different CPU.
Cause. Four command files are already open, and the fourth command file contains
an OBEY command that attempts to open a fifth command file. Only four command
files can be opened at the same time.
Effect. This OBEY command is not executed, and the next line (if any) from the fourth
OPEN command file is executed.
Recovery. Structure nested command files so that no more than four command files
are open at the same time.
Cause. An error was encountered while attempting to open a process started through
the RUN command.
TOO MANY ITEMS IN GROUP LIST; COMMAND NOT EXECUTED.
TOO MANY MEMBERS SPECIFIED; COMMAND NOT EXECUTED.
UNABLE TO ALLOCATE SEGMENT FOR SAFECOM.
UNABLE TO OPEN THE OBEY FILE; FOUR OBEY FILES ARE ALREADY OPEN.
UNABLE TO WRITE OPEN MESSAGE TO PROCESS; ERROR nnnn.