SCF Reference Manual for J-Series and H-Series RVUs

SCF Commands
SCF Reference Manual for J-Series and H-Series RVUs—529649-003
5-68
INFO Command
OBEYFORM
cause the INFO command to create a command file; that is, to produce an output
file that can be used as input to a TACL OBEY command.
The format of the regular INFO display is shown below.
The format of the detailed INFO display is shown below.
The format of the single-attribute INFO display is shown below.
Considerations
•
To display dynamic information about objects (such as state and trace
information), use the STATUS command (described on page 5-113).
•
The information displayed is subsystem-specific.
•
For more examples of how the syntax of an INFO command is affected by the
ASSUME command, refer to Effect of the ASSUME Command on Object-Name
Specification on page 5-5 and Effect of the ASSUME Command on Subdevice
Specification on page 5-6.
subsystem INFO object-type [ object-name AT \ system ]
NAME [*] attribute1 [*] attribute2 …
object-name value1 value2
subsystem The reporting subsystem name.
system The reporting system name.
object-type The object type of the specified object.
object-name The fully qualified name of the object.
[*] attribute n The name of an attribute of the specified object, preceded by
an asterisk (*) if the attribute is alterable, and a space if it is not
alterable.
value n The value of the attribute listed above it.
subsystem Detailed Info object-type object-name AT \ system
( n )
* attribute1 value1 [*] attribute2 value2
* attribute3 value3 [*] attribute4 value4
subsystem INFO object-type object-name
NAME [*] attribute1 [*] attribute2 …
object-name value1 value2