SCF Reference Manual for J-Series and H-Series RVUs

SCF Commands
SCF Reference Manual for J-Series and H-Series RVUs—529649-003
5-71
LISTDEV Command
LISTDEV Command
The LISTDEV command displays configured information about all processes that have
a device type and that are known to SCF, in the order in which they were configured
and as recorded in the destination control table.
OUT file-spec
causes any SCF output generated for this command to be directed to the specified
file. The variable file-spec is defined on page 5-9.
$ device
is the device name or device-name template of the devices for which information is
to be displayed. The variable $ device is defined on page 5-2.
subsystem
is the name of the subsystem for which a list of logical devices is desired.
Subsystem names are listed in Table 5-1 on page 5-10.
TYPE type [ , subtype ]
causes all logical devices of the given device type (and subtype, if specified) to be
included in the list. Supported subsystems are listed on Table 5-1 on page 5-10.
Specifying any negative value (for example, -1) in subtype results in a list of all
devices of the value specified in type .
The format of the LISTDEV display follows.
LISTDEV [ /OUT file-spec / ] [ $ device ]
[ subsystem ]
[ TYPE type [ , subtype ] ]
LDev Name PPID BPID Type RSize Pri Program
nnn $ process nn,nnn nn,nnn nn,nn nnnnn nnn \ sys. $ vol.subv.fn
nnn
$ process nn,nnn nn,nnn nn,nn nnnnn nnn \ sys. $ vol.subv.fn
LDev The logical-device number.
Name The logical-device name.
PPID The primary processor number and PIN of the specified device.
BPID The backup processor number and PIN of the specified device
Type The device type and subtype.