SCF Reference Manual for J-Series and H-Series RVUs

SCF Commands
SCF Reference Manual for J-Series and H-Series RVUs—529649-003
5-82
NAMES Command
NAMES Command
The NAMES command returns a list of the object names and types subordinate to the
specified object.
OUT file-spec
causes any SCF output generated for this command to be directed to the specified
file. The variable file-spec is defined on page 5-9.
object-spec
designates the device names to be displayed. The variable object-spec is
defined on page 5-2. If object-spec is omitted, the subordinate object names
and types of the assumed object are displayed (See ASSUME Command on
page 5-36.)
SUB [ subobjtype ]
selects the subordinate objects the command affects. The variable subobjtype
can be a subordinate object type or one of the keywords ONLY, ALL, or NONE, as
explained under SCF Subdevices on page 3-5.
SEL [ NOT ] state
directs the command only at objects in the specified state or only at those not in
the specified state. Valid states are listed in Table 3-1 on page 3-7. The use of
this option is subsystem-specific.
The format of the NAMES display is shown below.
NAMES [ /OUT file-spec / ] [ object-spec ]
[ , SUB [ subobjtype ] ] [ , SEL [ NOT ] state ]
subsystem Names object-type object-name
subobjecttype
subobject-name subobject-name subobject-name subobject-name
subobject-name subobject-name subobject-name subobject-name
.
.
.
subsystem The reporting subsystem name.
object-type The object type of the first-level object.