SCF Reference Manual for J-Series and H-Series RVUs

SCF Commands
SCF Reference Manual for J-Series and H-Series RVUs—529649-003
5-105
SETMANAGER Command
SETMANAGER Command
The SETMANAGER command allows you to explicitly set a subsystem manager
process name rather than having SCF determine the name. Use this command if the
subsystem you are working with uses many manager processes and you want to set a
default manager for a subsequent ADD command. The use of this command is
subsystem-specific.
This command is nonsensitive.
OUT file-spec
causes any SCF output generated for this command to be directed to the specified
file. The variable file-spec is defined on page 5-9.
\ system
is the name of the system on which the manager process exists. If omitted, the
default system name is used.
$ process
defines the name of a manager process for a subsystem to send commands to.
The variable $ process overrides the default name supplied by SCF.
Considerations
•
If you omit $ process , any previously entered SETMANAGER command (for the
specified subsystem name) is cleared.
•
Use the ASSUME command first to set the object type or object name. This
determines the subsystem to which subsequent commands are routed.
Examples
•
These commands specify that $SCCP1 be the manager, rather than the $SCCP
default, and then add a new line $ABC1:
-> SETMANAGER $SCCP1
-> ADD LINE $ABC1
These commands are the equivalent of this command, which specifies the object
type and object name:
-> ADD LINE $SSCP1.$ABC1
SETMANAGER [ / OUT file-spec / ] [ [ \ system .]$ process ]