SCF Reference Manual for J-Series and H-Series RVUs

SCF Commands
SCF Reference Manual for J-Series and H-Series RVUs—529649-003
5-114
STATUS Command
The format of the detailed STATUS display is shown below.
Consideration
To display configuration information (attributes and their values) for an object, use the
INFO command (described on page 5-67). INFO does not display dynamic
information.
Examples
•
This command displays status information about the $DATA00 disk:
-> STATUS DISK $DATA00
•
This command displays status information about the WS object named $L3.#WS1:
-> STATUS WS $L3.#WS1
•
This command displays status information about the WS objects under $L3:
-> STATUS WS $L3.*
•
This command displays status information about the WINDOW objects under
$L3.#WS1:
-> STATUS WINDOW $L3.#WS1
•
This command displays status information about the WINDOW objects (only those
in the STOPPED state) under $L3:
-> STATUS WINDOW $L3.*, SEL STOPPED
subsystem The reporting subsystem name.
object-type The object type.
object-name The fully qualified name of the object.
State One of the valid object states defined on Table 3-1 on page 3-7.
PPID The primary processor number and PIN of the selected device.
BPID The backup processor number and PIN of the selected device.
attrn The name of an object attribute.
valn The value of that attribute for that object.
subsystem Detailed STATUS object-type object-name
PPID nn,nnn BPID nn,nnn STATE state
attr1 val1 attr2 val2 attr3 val3