SCF Reference Manual for J-Series and H-Series RVUs

SCF Error Messages
SCF Reference Manual for J-Series and H-Series RVUs—529649-003
B-33
SCF Error Messages
Recovery. Specify TIMEOUT -1 to disable the timeout feature, or wait a few minutes
and retry the command.
20309
Cause. The Z subsys SCF product module is unable to allocate an extended segment
for product module use.
Effect. SCF waits for the next command.
Recovery. Refer to the Guardian Procedure Errors and Messages Manual to correct
the err-num ; then retry the command.
20310
Cause. File-system error err-num occurred while trying to use the NEXTFILENAME
procedure to search for product modules.
Effect. SCF waits for the next command.
Recovery. Refer to the Guardian Procedure Errors and Messages Manual for
recovery from the file-system error. Then retry the command.
20311
Cause. SCF is unable to communicate with the specified Z subsys SCF product
module.
Effect. SCF waits for the next command.
Recovery. Restart SCF and retry the command. If the problem continues contact your
service provider, as described under If You Have to Call Your Service Provider on
page B-2.
SCF 20309 Unable to allocate an extended segment for PM use,
PM = $ volume.subvol. Z subsys SCF, ERROR = err-num .
SCF 20310 Error retrieving PM filenames using NEXTFILENAME,
GUARDIAN error= err-num .
SCF 20311 Error communicating with Product module,
$ volume.subvol .Z subsys SCF SCF Kernel and Product module out
of sync.