SCF Reference Manual for J-Series and H-Series RVUs

SCF Error Messages
SCF Reference Manual for J-Series and H-Series RVUs—529649-003
B-47
Common Error Messages
Effect. SCF waits for the next command.
Recovery. Recovery is hardware-specific; check the modem, port, and so forth.
-00014
Cause. The named subsystem is unable to obtain memory space. Typically, this error
indicates a resource-availability problem caused by a large amount of activity
(assuming that the configuration is proper for the operating environment and that the
associated hardware is functioning normally).
Effect. SCF waits for the next command.
Recovery. Attempt to determine and correct the problem, or wait awhile before
reissuing the request.
-00015
Cause. An ADD request attempted to add an object already defined.
Effect. SCF waits for the next command.
Recovery. Informational message only; no corrective action is needed.
-00016
Cause. A request that would change the state of an object has been issued, and the
object is already in that state.
Effect. SCF waits for the next command.
Recovery. Informational message only; no corrective action is needed.
-00017
Cause. The object specified by the object name cannot be found within the
subsystem. Usually this means that the object has not yet been added. This error
subsystem {E|W}-00014 Unable To Obtain Memory: text for
object-name.
subsystem {E|W}-00015 Object object-name Already Defined.
subsystem {E|W}-00016 Object object-name is already in
summary-state state.
subsystem {E|W}-00017 Object object-name Not Found for
device- type num and subdevice-type num .