SNAX/HLS Diagnosis and Support Manual

Command Dictionary
Using SNAX/HLS Trace Analysis Program
104706 Tandem Computers Incorporated 2–19
Figure 2-2. Example of INFO Command Display
@info $sna2.#p0l001
Session HS Open Profile Appl Max Xlate LMO
ID Name Plrty Mode Name Name Req Ind
-------------------------------------------------------------
1 $SNA2.#P0L001 SLU acquire _PSLUA 2 YES NO
- - - - - - - - Application Interface Profile - - - - - - -
Encode ERI YES Want Bind Data YES
Pipeline LU ind YES Want Flow Control NO
Response type 1 Want SSCP Text NO
User Responses YES Single FMH YES
Omit Modem Wait NO Bid Rejection no_rtr
Accept Bind NO Force RTS NO
- - - - - - - - Session Bind Parameters - - - - - - - - - - -
FM Profile 4 TS Profile 4
PRI Chain Use single_ru SEC Chain Use single_ru
PRI Rq Mode immediate SEC Rq Mode immediate
PRI Chain Protocol exception SEC Chain Protocol exception
PRI Two Phase Commit NO SEC Two Phase Commit NO
PRI Compression Ind NO SEC Compression Ind NO
PRI EB Send NO SEC EB Send NO
PRI Pacing Window 0 SEC Pacing Window 3
PRI Max RU 32 SEC Max RU 32
No Segments NO FM Header Use YES
Brkt Reset inb Brkt Term unconditional
Alt Code Use NO Seqno Use NO
BIS Sent NO Bind Queueing NO
Send Recv fdux Recovery Mode loser
Contention Winner secondary Alt Code ID ascii_7
HDX FF Reset Sender secondary
The diagram comprises three sections :
General Information
Application Interface Profile
Session Bind Parameters
General Information
Session ID This is the session ID of the SNAX/HLS session.
Session Name This is the name of the LU being used by the session.
HS Plrty This is the polarity of the session partner (SLU or PLU). In this case
it is the secondary (SLU).
Open Mode Acquire or accept. This is defined in the PROFILE record of the
RDT table.