SNAX/HLS Diagnosis and Support Manual

Command Dictionary
Using SNAX/HLS Trace Analysis Program
2–20 104706 Tandem Computers Incorporated
Profile Name This is the name of the PROFILE under which the session was
established.
Appl Name This is the PLU name carried in the BIND request.
If the LU is type PLU, then the PLU name sent in the BIND is the
name in the APPLICATION-NAME field of the OPEN-SESSION or
HLS-OPEN verb. If this field is empty, then the PLU-NAME in the
BIND record in the RDT table is used.
If the LU type is PLU and the open mode is ACCEPT, the
APPLICATION-NAME field in the open verb is empty, and there is
no PLU-NAME in the BIND record in the RDT table, the DLU name
in the INIT-SELF is sent as the PLU name in the BIND request.
Max Req This is the value of the MAX-REQUESTS PROFILE attribute. It is
the maximum number of requests allowed to be concurrently
outstanding on the session.
Xlate Ind This is the value of the TRANSLATE PROFILE attribute. It dictates
if translation is requested on the session. It may be modified
during the course of the session; this, however, is its value at
session initiation.
LMO This is the value of the LMO PROFILE attribute. It may be
modified during the course of a session, but this is its initial value
at session initiation.
Application Interface Profile
For a full description of the PROFILE attributes, some of which also appear in the
section General Information, refer to the SNAX/HLS Configuration and Control
Manual.
Session BIND Parameters
The session BIND parameters reflect the protocol rules used by the SNA session. Refer
to the SNAX/HLS Configuration and Control Manual and to the IBM SNA Reference
Summary for more information.