SNAX/HLS Diagnosis and Support Manual

HLSTAP Error Messages
Error Messages
104706 Tandem Computers Incorporated B–5
HLSTAP Error
Messages
The following error messages are generated by the HLSTAP program.
End of trace file reached
Cause. The HLSTAP program unexpectedly encountered the end of the trace file
before reaching the requested record.
Effect. The command fails.
Recovery. This message can be considered an informational message. However, if you
expected to see more records, check the command, especially the number that you
entered, and reissue the corrected command.
Incompatible trace file version
Cause. The trace file is incompatible with the version of the HLSTAP program. The
HLSTAP program can only analyze trace files that were created with corresponding
versions of SNAX/HLS.
Effect. The command fails.
Recovery. Ensure that you are using the correct version of the HLSTAP program. If the
trace file was created using an older version of SNAX/HLS, recreate the trace file, if
possible (or use the matching older version of HLSTAP).
Invalid ending record number
Cause. The record number specified in a RECORD command is badly formed.
Effect. The command fails.
Recovery. Correct the record number and reissue the command.
Invalid trace input file name
Cause. The name specified in the FROM command identified an invalid trace file.
Effect. The command fails.
Recovery. Correct the file name, (check the spelling of the file name), and reissue the
command.