SNAX/HLS Diagnosis and Support Manual

SNAX/HLS Log Messages
104706 Tandem Computers Incorporated C–15
process name : This product requires a NonStop processor and an
XF release C00 or better
Cause. The product was initiated on an inappropriate CPU.
Effect. The process terminates.
Recovery. Move the application to an appropriate processor.
process name : Too many takeovers
Cause. Since the process was initiated or the operator intentionally caused the primary
process to fail, the process has gone through a takeover sequence more than six times
within the last 30 minutes (approximately). Furthermore, each of these takeovers was
due to abnormal termination of the primary process.
Effect. A new backup process is not started. The backup CPU is undefined; if you
need a backup CPU, you must explicitly name one in the ALTER BACKUPCPU
HLSCOM command.
Recovery. A serious problem exists in the subsystem. Gather the information
discussed at the beginning of Section 1, "Problem Determination" and contact your
Tandem analyst.
process name : Unrecognized parameter: parameter nam e
Cause. A startup command contained a malformed or unrecognized configuration
parameter name.
Effect. The SNAX/HLS process abends.
Recovery. Correct the startup parameters in the RUN command. If the problem
persists, gather the information described at the beginning of Section 1, "Problem
Determination" and call your Tandem analyst.
process name : Unrecognized systems message on $RECEIVE, code:
message
Cause. An unexpected systems message was sensed on $RECEIVE. message gives
the value in the first word of the message.
Effect. The request is rejected with error 60, but the process proceeds.
Recovery. Informational message. No action necessary.