SSL Reference Manual

DONOTWARNONERROR
Use this parameter to log selected errors with LOGLEVEL 20 rather than as WARNING. By default, all errors on
sockets result in a WARNING being displayed in the HP NonStop SSL log. Using this parameter, a log message with
LOGLEVEL 20 will be issued instead for the configured error numbers.
Parameter Syntax
DONOTWARNONERROR ErrorList
Arguments
ErrorList
specifies a list of comma-separated error numbers
Default
If omitted, HP NonStop SSL will use an empty entry.
Example
DONOTWARNONERROR 4120
Considerations
• The example shown will yield in error 4120 ("Connection reset by remote") generating a log message with
LOGLEVEL 20 rather than a WARNING.
DYNAMICROUTINGENABLEIPV6
This parameter is only valid in ROUTINGMODE D (dynamic routing) and must be used when IPv6 addresses are to be
used as the dynamic targets. The parameter will cause the expected separator between the target host IP address and the
target port to be a pipe symbol ('|') instead of a colon (':'). Please see parameter ROUTINGMODE for more details.
Parameter Syntax
DYNAMICROUTINGENABLEIPV6 {TRUE|FALSE}
Default
FALSE
Example
DYNAMICROUTINGENABLEIPV6 TRUE
See Also
ROUTINGMODE
EXPANDCOMPRESSION
This parameter controls if compression is used in Expand mode. Compression can improve the throughput of Expand
connections. An additional license is required to enable compression. Contact HP if interested.
Parameter Syntax
EXPANDCOMPRESSION {TRUE|FALSE*}
Default
If omitted, the default will be FALSE, i.e. no Expand compression will be used.
56 • Configuration HP NonStop SSL Reference Manual