Tandem Failure Data System (TFDS) Manual

Glossary
HP Tandem Failure Data System (TFDS) Manual—540122-003
Glossary-9
reintegration
reintegration. When a processor element has diverged or has been added or replaced,
memory is copied from a functioning NonStop Blade Element to the replaced or added
NonStop Blade Element, and the processor element is reintegrated into the logical
processor.
relative pathname. In the Open System Services (OSS) file system and Network File
System (NFS), a pathname that does not begin with a slash (/) character. A relative
pathname is resolved beginning with the current working directory. Contrast with
absolute pathname.
release version update (RVU). A collection of compatible revisions of HP NonStop
operating system software products, identified by an RVU ID, and shipped and
supported as a unit. An RVU consists of the object modules, supporting files, and
documentation for the product revisions. An RVU also includes a set of documentation
for the overall RVU.
RELOAD. An HP Tandem Advanced Command Language (TACL) command to load the HP
NonStop™ operating system image from disk over the ServerNet fabrics into the
memory of the processor.
remote access. A form of remote support, configured in the OSM Notification Director.
Remote access, or dial-in, allows a service provider to dial in to your system console
and access your HP NonStop™ server to diagnose hardware and software problems.
See also remote notification.
remote notification. A form of remote support. Remote notification, or dial-out, allows the
OSM Notification Director to notify a service provider, such as the Global Customer
Support Center (GCSC), of pending hardware and software problems. See also remote
access.
remote system. An active ServerNet node to which the local system has active external
ServerNet paths. Contrast with local system.
RESTORE. A utility for HP NonStop™ servers that copies files from a backup tape to disk.
See also BACKUP.
S-series servers. See HP NonStop™ S-series servers.
save file. A file created by the Inspect subsystem in response to a command from a
debugger. A save file contains enough information about a running process at a given
time to restart the process at the same point in its execution. A save file contains an
image of the process, data for the process, and the status of the process at the time
the save file was created.
A save file can be created through an Inspect SAVE command at any time. A save file
called a saveabend file can be created when a process’s SAVEABEND attribute is set
and the process terminates abnormally. Other debuggers can create a save file but
refer to the result as a process snapshot file.