Tandem Failure Data System (TFDS) Manual

Managing and Configuring TFDS
HP Tandem Failure Data System (TFDS) Manual—540122-003
2-10
Viewing the Current TFDS Configuration Settings
Viewing the Current TFDS Configuration Settings
To view the current settings of the TFDS configuration attributes, use the TFDSCOM
CONFIG command. (For additional information, see CONFIG on page 3-15).
CONFIG Command Example
tfdscom> config
TFDS current configuration:
AutoBackup OFF
AutoDump ON
AutoReintegrate ON
AutoReload ON , Delay 0 seconds
AutoStifle 03 Times in 24 Hours
BurstNotify 15 Times in 7200 Minutes
BurstSuppression ON
BurstInterval 336 hours
DumpOverride OFF
MaxConDumps 3
Retry-Reload 2
Retry-Dump 1, Reload-on-Failure, Reintegrate-on-Failure
-----------------------------------------------------------------------
CPUS 00 01 02 03 04 05 06 07 08 09 10 11 12 13 14 15
Enabled XX XX XX XX XX XX XX XX XX XX XX XX XX XX XX XX
Disabled none
Ignored none
Status ON ON ON ON DN DN DN DN DN DN DN DN DN DN DN DN
Memory Size 04 04 04 04 00 00 00 00 00 00 00 00 00 00 00 00
-----------------------------------------------------------------------
ConfigFile $SYSTEM.ZTFDS.TFDSCONF
DB-subvol \DRP09.$SYSTEM.ZTFDS
Max-DB-Entries 500
Tape not assigned
DumpVolume not assigned
Disallowed-Volumes $SYSTEM
Files to be collected for ALL PROCESSORS:
\DRP09.$SYSTEM.SYS00
CMAP INITDLL MCPDLL NIDLEAP NMEMMAN NMERAP NMONTOR
NMSNGERR
NSMIPAP NSMIPIP NSNIFAPC NSQMPROC NTIMEIP NWATCHDC OIFMR OSIMAGE
TMFMON TSCOMIP TSERRIP TSL TSMSGIP TSSTRIP TSTIMAP TXMON
ZDBGMONE ZGFHE ZIBIPE ZIMPIMP ZMABIPE ZSAME ZSTME
$A.B.C
\NSKNED.$A.TEMP.TEST
Files also collected for PROCESSORS 0 AND 1:
\DRP09.$SYSTEM.SYS00
NZNUP OAUX OCDIST OPCOLL TMIOP TSYSDP2 TZCNF