Tandem Failure Data System (TFDS) Manual

Managing and Configuring TFDS
HP Tandem Failure Data System (TFDS) Manual—540122-003
2-12
Changing the TFDS Configuration
Changing the TFDS Configuration
Making Changes Interactively
You can make changes interactively to the TFDS configuration by using these
TFDSCOM commands:
•
ACQUIREFILES on page 3-4
•
ANALYZEPRIORITY on page 3-6
•
AUTOBACKUP on page 3-6
•
AUTODUMP on page 3-7
•
AUTOREINTEGRATE on page 3-8
•
AUTORELOAD on page 3-8
•
AUTOSTIFLE on page 3-9
•
BACKUPDELAY on page 3-11
•
BURSTINTERVAL on page 3-12
•
BURSTNOTIFY on page 3-12
•
BURSTSUPPRESSION on page 3-13
•
DB-SUBVOL on page 3-16
•
DISABLECPUS on page 3-17
•
DUMPALLSLICES on page 3-18
•
DUMPOVERRIDE on page 3-19
•
DUMPVOLUME on page 3-19
•
EXCLUDEFILES on page 3-21
•
FULLANDEXTRACTED on page 3-23
•
IGNORECPUS on page 3-26
•
IGNOREOPERATORHALTS on page 3-27
•
MAXCONDUMPS on page 3-28
•
MAX-DB-ENTRIES on page 3-28
•
PROCESSINGDELAY on page 3-29
•
REMOTENOTIFY on page 3-30
•
RETRY-DUMP on page 3-33
•
RETRY-RELOAD on page 3-34
•
TAPE on page 3-37
•
TRACE-FILE on page 3-41
Note. You can make interactive configuration changes permanent with the TFDSCOM SAVE
command. (See SAVE
on page 3-34.) If you do not save changes you make interactively, they
are lost the next time TFDS is restarted.