Tandem Failure Data System (TFDS) Manual

Managing and Configuring TFDS
HP Tandem Failure Data System (TFDS) Manual—540122-003
2-13
Changing the TFDS Configuration
Editing the TFDS Configuration File
You can make changes to your TFDS configuration by editing your TFDS configuration
file, which is located in the TFDS execution subvolume (usually $SYSTEM.ZTFDS).
You can use these commands in your TFDS configuration file:
•
ACQUIREFILES on page 3-4
•
ADD on page 2-14
•
ALTERNATE-VOLUMES on page 2-16
•
ANALYZEPRIORITY on page 3-6
•
AUTOBACKUP on page 3-6
•
AUTODUMP on page 3-7
•
AUTOREINTEGRATE on page 3-8
•
AUTORELOAD on page 3-8
•
AUTOSTIFLE on page 3-9
•
BACKUPDELAY on page 3-11
•
BURSTINTERVAL on page 3-12
•
BURSTNOTIFY on page 3-12
•
BURSTSUPPRESSION on page 3-13
•
DB-SUBVOL on page 3-16
•
DISABLECPUS on page 3-17
•
DISALLOWED-VOLUMES on page 2-16
•
DUMPALLSLICES on page 3-18
•
DUMPOVERRIDE on page 3-19
•
DUMPVOLUME on page 3-19
•
EXCLUDEFILES on page 3-21
•
FULLANDEXTRACTED on page 3-23
•
GARTH-FILE on page 2-17
•
IGNORECPUS on page 3-26
•
IGNOREOPERATORHALTS on page 3-27
•
MAXCONDUMPS on page 3-28
•
MAX-DB-ENTRIES on page 3-28
•
MAXWAITFORRELOAD on page 2-18
•
OSMDELAY on page 2-18
•
PROCESSINGDELAY on page 3-29
•
REMOTENOTIFY on page 3-30
•
RETRY-DUMP on page 3-33
•
RETRY-RELOAD on page 3-34
•
SNAPSHOTFROMDUMP on page 2-19
•
TAPE on page 3-37
•
TRACE-FILE on page 3-41
Note. When you insert commands into the TFDS configuration file, the changes do not take
effect until you stop and then restart TFDS. (For more information, see Stopping TFDS
Processes Manually on page 2-5 and Starting TFDS Processes Manually on page 2-5.)