Tandem Failure Data System (TFDS) Manual

Managing and Configuring TFDS
HP Tandem Failure Data System (TFDS) Manual—540122-003
2-17
TFDS Configuration-File-Only Commands
Guideline
$SYSTEM is automatically disallowed by TFDS.
Example
DISALLOWED-VOLUMES $KERBEY
GARTH-FILE
The GARTH-FILE command specifies the file that TFDS will use to run the GARTH
process.
filename
specifies a Guardian file name.
Guidelines
•
This command is intended for use only by development or support groups or under
their direction.
•
If the filename is not fully qualified or is invalid, the volume and subvolume will
be assigned to the default location in the following order:
1. $SYSTEM.SYSTEM.EGARTH
2. $SYSTEM.SYSnn.EGARTH
However, the new assigned location will not be saved in the TFDS configuration
file.
Examples
GARTH-FILE $FFDC.SUPPORT.R050321
Guidelines
•
You can use the abbreviation ih in place of IGNOREOPERATORHALTS.
•
It is recommended that you never set IGNOREOPERATORHALTS to OFF in a
production system environment.
Example
•
This example sets IGNOREOPERATORHALTS to ON:
IGNOREOPERATORHALTS ON
GARTH-FILE filename
Note. While creating the default TFDS configurations file, GARTH-FILE is assigned to the
$SYSTEM.SYSTEM.EGARTH location.