Tandem Failure Data System (TFDS) Manual

Using TFDSCOM
HP Tandem Failure Data System (TFDS) Manual—540122-003
3-12
TFDSCOM Commands
Example
BACKUPDELAY 20
BURSTINTERVAL
The BURSTINTERVAL command sets the number of hours that a rediscovery incident
will be part of a burst. With BURSTSUPPRESSION enabled, no entry is created in the
incident database, and no event is sent to the maintenance log ($ZLOG).
hours
is the number of hours a rediscovery incident will be part of a burst. The hour
range is 0 through 600. The default value is 336 hours.
Guidelines
•
You can use the abbreviation bi in place of BURSTINTERVAL.
•
You must set BURSTSUPPRESSION to ON for BURSTINTERVAL to start.
•
BURSTINTERVAL does not override the BURSTSUPPRESSION setting.
•
For a suppressed incidents report, use the TASKS command.
Example
BURSTINTERVAL 24
BURSTNOTIFY
The BURSTNOTIFY command provides a rediscovery window that creates a summary
event in the maintenance log ($ZLOG) and a dial-out to your service provider (if OSM
is configured for automatic dial-out).
num-times
is the number of incident rediscoveries within the interval. The incident range is 1
through 101. The default value is 15.
num-minutes
is the number of minutes in the interval. The minute range is 1 through 25200. The
default value is 7200.
BURSTINTERVAL hours
BURSTNOTIFY num-times[,]num-minutes