Tandem Failure Data System (TFDS) Manual

Using TFDSCOM
HP Tandem Failure Data System (TFDS) Manual—540122-003
3-23
TFDSCOM Commands
The subcommand begins its operation at the character positioned directly above it. To
stop editing the line, press Enter.
Specify more than one subcommand on a line by separating each subcommand with a
double slash (//).
Example
This example uses the FC command and the d and i subcommands to get help on the
AUTOBACKUP command:
TFDSCOM> fc
TFDSCOM> HELP AUTODUMP
tfdscom...........ddddiBACKUP
TFDSCOM> HELP AUTOBACKUP
tfdscom......
FULLANDEXTRACTED
The FULLANDEXTRACTED command instructs TFDS to collect the extracted dump,
or both full and extracted dumps depending upon the type of system (NonStop
advanced architecture (NSAA) or non-NSAA), after a processor is halted.
ON
For the NSAA system: Full and extracted dumps are captured.
For the non-NSAA system: Full and extracted dumps are captured.
OFF
For the NSAA system: Full and extracted dumps are captured.
For the non-NSAA system: Only the extracted dump (smart dump) is captured.
Example
FULLANDEXTRACTED ON
HELP
The HELP command displays the syntax for TFDS commands.
FULLANDEXTRACTED { ON | OFF }
HELP [ command ]
[ command_name ]
[ document ]
[ events ]
[ revisions ]