Tandem Failure Data System (TFDS) Manual

Using TFDSCOM
HP Tandem Failure Data System (TFDS) Manual—540122-003
3-29
TFDSCOM Commands
PROCESSINGDELAY
The PROCESSINGDELAY command instructs TFDS to wait a specific number of
seconds before it starts the analysis and possible dump of a down processor.
time
is the delay in seconds. Seconds can range from 0 through 86400. The default
value is 1.
Guidelines
•
You can use the abbreviation pd in place of PROCESINGDELAY.
•
PROCESSINGDELAY is valid only for SMR processors. (It is ignored in DMR and
TMR processors.)
•
The TFDS default time allows other processes to get access to the processor for
data gathering.
Example
PROCESSINGDELAY 300
PURGE
The PURGE command purges the files associated with the specified incident number.
rec-num
is a record number in the incident database. To obtain a record number, use the
REPORT command.
Guidelines
•
You can use the abbreviation pu in place of PURGE.
•
If the files cannot be purged, an error message appears.
If this situation occurs, use the REPORT command to find the files and use the
TACL FILEINFO command to identify any possible errors.
•
Before you can purge an original incident record, you must close all of the
recurrent problem files associated with it.
Example
PURGE 201
PROCESSINGDELAY time
PURGE rec-num