Tandem Failure Data System (TFDS) Manual

Using TFDSCOM
HP Tandem Failure Data System (TFDS) Manual—540122-003
3-34
TFDSCOM Commands
If the TFDS dump fails and the REINTEGRATE-ON-FAILURE option is not
specified, the NSBE is be reintegrated for approximately 1 hour. This delay
enables you to continue efforts to obtain a valid processor dump by trying to dump
the NSBE left in the stopped state. See AUTOREINTEGRATE on page 3-8.
•
In all processor configurations (SMR, DMR and TMR), there is a 45-second delay
between each attempts at taking a dump.
Examples
•
This example sets the RETRY-DUMP count to 2:
RETRY-DUMP 2
•
This example sets the RETRY-DUMP count to 2 and sets REINTEGRATE-ON-
FAILURE:
RETRY-DUMP 2, REINTEGRATE-ON-FAILURE
•
This example sets the RETRY-DUMP count to 1 and sets RELOAD-ON-FAILURE:
RETRY-DUMP 1, RELOAD-ON-FAILURE
RETRY-RELOAD
The RETRY-RELOAD command sets the number of attempts TFDS makes to reload a
processor if the initial reload is unsuccessful.
retry-number
represents the maximum number of times TFDS attempts to reload a failed
processor. The reload range is 0 through 2. The default value is 2.
Example
RETRY-RELOAD 2
SAVE
The SAVE command saves the current configuration to the TFDS configuration file.
When you restart TFDS, initial command settings are read from the TFDS
configuration file.
filename
represents a file name for the saved configuration file.
RETRY-RELOAD retry-number
SAVE [ filename ]